Great Snakes!

great snakesYou’re walking through the jungle when, suddenly…a snake slides onto your shoulders. Stop! Do NOT panic! It’s perfectly safe. This snake is made out of self-adhesive foam!

You’ll need:

First, trace the 2 halves of your snake onto a 9″ x 12″ sheet of self-adhesive foam (I purchase my sheets from Blick Art Supplies and Michaels Craft store). The “head” half of my snake was approximately 11″ long. The “tail” half was approximately 12″ long.

Cut both snake halves out, but don’t peel the backing from them just yet. The next step is to cut, peel, and stick little pieces of foam to your snake’s body. I did a triangle pattern, but stripes also look fantastic. And don’t forget the eye!

snake halvesWhen the snake is decorated to your satisfaction, peel the backing off the big pieces and stick them to the front of your shirt. It looks best if you wrap the ends a little past your shoulders.

finished shoulder snakeIf you’d like to add a tongue to your snake, fork one end of a 2″ piece of curling ribbon, and stick it to the underside of the snake’s head.

snake tongueIt’s important to note that the snake doesn’t go all the way around your neck. This foam doesn’t do too well on long, uneven curves. I didn’t want it to buckle, pop off, and tangle in (or stick to)¬†longer hair.

snake from the backI tested the foam on plain t-shirts, as well as shirts with embroidery, plain decals, and glitter decals. All of them were fine, with the minor exception being the glitter decal. The foam did take some glitter off with it, but no more than comes off when you rub the decal with your fingers. However, when I peeled the foam off a mesh sports jersey with vinyl numbers, bits of the foam ripped off the snake and stuck to the vinyl numbers! So if you’re wearing a mesh sports jersey, peel slowly, and know that you might have to do a little extra peeling where the foam sticks.

And there you have it! A super easy shoulder snake, ready for your next story time. May I suggest Snake, His Story by James Marshall? It’s one of my favorites!

Come On Get Snappy

get snappySnapdragon anyone? I’ve offered this simple project at a number of programs in the past, and it’s always well-received. “Snappy” has decorated the edges of a swamp at a Halloween party, hid in an Alice in Wonderland garden, and grown out of pots at a “Primordial Plants” event table!

event tableYou’ll need:

  • 1 paper cup
  • 1 small rectangle of green construction paper for head (approximately 1.5″ x 3″)
  • A sliver of red construction paper for tongue
  • 1 green pipe cleaner
  • Hole punch
  • Tape
  • Markers
  • Extra green construction paper for leaves

First, fold the green construction paper rectangle in half to form Snappy’s mouth. Tab the ends of the mouth, then cut out teeth.

mouth stepsMake sure to leave a gap in the lower teeth (this is where the tongue will rest later).

gapNext, punch a hole in the back of Snappy’s head…

punched holeThen thread a green pipe cleaner through the hole. Twist the pipe cleaner around and thread it through the hole once again. Pull gently to tighten, then curl the end.

stem steps Cut the sliver of red construction paper to look like a forked tongue and tape (or glue) it into the mouth.

tongueUse markers to draw eyes. I added my eyes at the very end, but younger kids might have an easier time drawing the eyes earlier, such as before they attach the head to the pipe cleaner stem.

close up of faceTape the pipe cleaner stem inside the paper cup. Use extra green construction paper to add foliage. Done! Perhaps you can test out your new Snappy skills with this garden story time?